05-31-2020 06:11 AM
Hi,
i got Cisco C1111-8PLTELAWZ router on 4G LTE.
Currently, its connected with Band 7 (2600MHz) . How to force router to use Band 28 (700MHz).
Also, how to enable Carrier Aggregation on LTE?
Thanks
05-31-2020 12:46 PM
Hello,
I think you have to change your modem settings to:
C1111#cellular 0/2/0 lte technology auto
06-01-2020 04:27 AM
George,
Thanks fro the reply.
i am using that config. but, its giving priority to Band 7.
06-03-2020 12:38 AM
hi,
i found the solution.
actual solution is on IOS XE 16.10 and after release.
show cellular X/Y/Z radio band
And you’ll see the supported bands with its corresponding index number.
In order to force the modem to select a specific band issue the following commands:
config term
controller cellular interface X/Y/Z
lte modem band-select band-indices “Index number”
end
On other devices the option of "band-indices" is not available so we can use the command:
lte modem band-select indices [band]
04-21-2021 08:20 PM
This only works on IOS-XE. C900 series uses IOS which apparently doesn't support the commands above.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide