PoE on C891F-K9 not working

[ROBERT T]

I need some help getting PoE working on a C891F-K9 running c800-universalk9-mz.SPA.153-3.M6.bin.

Is there a special config needing to be added to make this work? 

The regular power commands on the interface are not valid.

It's my understanding that the 891F supports PoE. It only has a single power cord and jack that says PoE on it. I have my AP in port gig0.

[Leo Laohoo]

Can you please post the complete output to the command "sh inventory raw".

[ROBERT T]

NAME: "C891F-K9", DESCR: "C891F-K9 chassis, Hw Serial#: FCZ<REMOVED>, Hw Revision: 1.0"
PID: C891F-K9 , VID: V02, SN: FCZ<REMOVED>

NAME: "C891F Chassis Slot 0", DESCR: "C891F Chassis Slot"
PID: , VID: , SN:

NAME: "C891F Mother board on Slot 0", DESCR: "C891F Mother board"
PID: C891F-K9 , VID: V02, SN: FOC<REMOVED>

NAME: "GigabitEthernet8", DESCR: "PQ3_TSEC"
PID: , VID: , SN:

NAME: "c89X-1GE SFP Container 0/0", DESCR: "c89X-1GE SFP Container 0/0"
PID: , VID: , SN:

NAME: "BRI0", DESCR: "BRI with S/T interface"
PID: , VID: , SN:

NAME: "FastEthernet0", DESCR: "PQII_PRO_UEC"
PID: , VID: , SN:

NAME: "GigabitEthernet0", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "GigabitEthernet1", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "GigabitEthernet2", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "GigabitEthernet3", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "GigabitEthernet4", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "GigabitEthernet5", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "GigabitEthernet6", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "GigabitEthernet7", DESCR: "Gigabit Ethernet"
PID: , VID: , SN:

NAME: "Async3", DESCR: "Analog Modem"
PID: , VID: , SN:

NAME: "Container of powerSupply Containers", DESCR: "Container of powerSupply Containers"
PID: , VID: , SN:

[Leo Laohoo]

The router doesn't have a PoE daughterboard (800-IL-PM-4) so it won't support PoE.