cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
488
Views
4
Helpful
1
Replies

policing

bellocarico
Level 1
Level 1

What is the difference between these 3 commands?

R1(config-map)police XXX

R1(config-map)police cir XXX

R1(config-map)police rate XXX

?

Thanks to read.

1 Reply 1

royalblues
Level 10
Level 10

from the command lookup table

police

To configure traffic policing, use the police command in policy-map class configuration mode or policy-map class police configuration mode. To remove traffic policing from the configuration, use the no form of this command.

police bps [burst-normal] [burst-max] conform-action action exceed-action action [violate-action action]

police (two rates)

To configure traffic policing using two rates, the committed information rate (CIR) and the peak information rate (PIR), use the police command in policy-map configuration mode. To remove two-rate traffic policing from the configuration, use the no form of this command.

police cir cir [bc conform-burst] pir pir [be peak-burst] [conform-action action [exceed-action action [violate-action action]]]

police rate (control-plane)

To configure traffic policing for traffic that is destined for the control plane, use the police rate command in policy-map class configuration mode. To remove traffic policing from the configuration, use the no form of this command.

Syntax for Packets Per Seconds

police rate units pps [burst burst-in-packets packets] [peak-rate peak-rate-in-pps pps] [pack-burst peak-burst-in-packets packets]

HTH, rate if it does

Narayan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: