cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
267
Views
1
Helpful
4
Replies

Port forward CISCO2901/K9

Hello

I have a finger print machine, I want to connect it through internet remotely so I must make port forwarding in the router which is CISCO2901/K9, I did but it will not be opened still by checking in this website(https://ping.eu/port-chk/) by using the the public IP and the port.

please someone check the configuration attached to see what is wrong?

Best Regrds

 

 

4 Replies 4

Flavio Miranda
VIP Mentor VIP Mentor
VIP Mentor

Hi

 The NAT you setup will work fine for connection from the inside network to the outside. But, if I understood it correctly you want the opposite. 

 Take a look on this link

https://www.cisco.com/c/en/us/support/docs/ip/network-address-translation-nat/13770-1.html

 

MHM Cisco World
VIP Mentor VIP Mentor
VIP Mentor
access-list 100 permit ip 192.168.xx.xx 0.0.0.xx any <<- this IPsec ACL effect the NATing can you change any to remote LAN subnet 

 

@MHM Cisco World 

Thanks for reply.

I dont have enough expreince please let me what should I write,remove or Change?

please answer me with comands

sure 
what is your local and remote LAN subnet ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers