cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
628
Views
0
Helpful
3
Replies
Vivien FRANCOIS
Beginner

[PPPoE] - Show authentication protocol used

Hi,

When connected to a DSL service provider with a Cisco router using a dialer's basic configuration as follow:

interface Dialer1

ip address negotiated

[OUTPUT_OMITTED]

encapsulation ppp

dialer pool 1

dialer idle-timeout 0

dialer persistent

ppp authentication pap chap callin

ppp chap hostname [OUTPUT_OMITTED]

ppp chap password 0 [OUTPUT_OMITTED]

ppp pap sent-username [OUTPUT_OMITTED] password 0 [OUTPUT_OMITTED]

!

Is there a way to see whcich authentication protocol (PAP, CHAP...) has been used other than running a debug ppp authentication while authenticating ?

Thank you.

Vivien F.

1 ACCEPTED SOLUTION

Accepted Solutions
paolo bevilacqua
Hall of Fame Master

There is no way beside using debiug command. Note for PPPoE you do not need:

dialer idle-timeout 0

dialer persistent

View solution in original post

3 REPLIES 3
paolo bevilacqua
Hall of Fame Master

There is no way beside using debiug command. Note for PPPoE you do not need:

dialer idle-timeout 0

dialer persistent

Ok thank you very much for the prompt answer.

Merry Christmas.

Thank you for the nice rating and good luck!