Hi,
I have one 2851
router with HWIC-2CE1T1-PRI at HO side and three 1841 at branch side
with bri and serial interfaces . i want to configure lease line as a
primariry and isdn pri /bri as a backup link . HO and branch are point
to point .I am new in these kind of setup so pls give me some examples
or technotes . ASAP
Regards
Mak
Hi Mak,
Check out the below link hope this helps !!
http://www.cisco.com/en/US/tech/tk713/tk237/technologies_configuration_example09186a00800a3b77.shtml
Ganesh.H
If helpful do rate the post