PRI Provisioning

[dennylester]

I have a Cisco 2811 with a NM-2CE1T1-PRI network module. We plan to use this for backups via demand dial routing to remote Cisco routers with BRI cards.

I am placing my PRI order and was sent this provisioning form to fill out. It seems very PBX specific so I need a little help.

General Provisioning Information

Framing: I put B8ZS/ESF

Digits to complete call (3/4/10): I put 10

DS1 Specific Provisioning Information

Out pulse type (DTMF or Dial Pulse): ??

Supervision Signaling: (E&M or Other): ??

In & Out Start Signaling (Immediate or Wink): ??

Outgoing Trunk Selection: ???

Dial Tone (PBX Provided or Carrier Provided): ??

Thank you in advance,

Denny

[jim_berlow]

The framing and digits sound fine. I would ask your provider about the other parameters - I don't think they really pertain to what your doing. This is probably a generic form that is provided for all PRI's and this info would be needed if you were connecting it to your PBX.

[dennylester]

Thank you for clarifying this. Hopefully they will know how to configure it on their end.

Now I need to find some articles on how to configure it on my end. :-)

Denny

[paolo bevilacqua]

Jim is correct, the "DS1 specific parameters" would only apply for a CAS circuit, but wisely you're requesting PRI.