cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1065
Views
3
Helpful
3
Replies

Problem pinging from VLAN1

retosteinemann
Level 1
Level 1

Hi

I have a problem with my Cisco 887V VDSL-router. The router gets a ip-address with dhcp from my provider. That works fine. I also can ping from the router:

routerVdslTestNew#ping google.ch source vlan 1

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 74.125.79.99, timeout is 2 seconds:

Packet sent with a source address of 10.10.10.1

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 48/48/52 ms

My problem: If I want to ping google from a computer in the VLAN1 the ping doesn't work.

C:\Users\XXXXXX>ping 74.125.79.99


Ping wird ausgeführt für 74.125.79.99 mit 32 Bytes Daten:

Timeout.

What did I configure wrong? The configuration is attached to this post.
Thanks!
1 Accepted Solution

Accepted Solutions

Hi,

In config mode reenable ip routing with the ip routing command.

Regards.

Alain.

Don't forget to rate helpful posts.

View solution in original post

3 Replies 3

mrdogantr
Level 1
Level 1

can you post "sh ip int brie" and "sh ip nat trans" outputs.

Hi,

In config mode reenable ip routing with the ip routing command.

Regards.

Alain.

Don't forget to rate helpful posts.

Thank you! That was it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card