08-06-2009 06:38 AM - edited 03-04-2019 05:40 AM
During initial setup of 1841 router, after I logged in as initial user(cisco), there were power brake down, so my pc and router restarts. Problem is I didn't manage to create new user, so now I cannot login to route. Is there any way to create user now, so that i can configure router?
Thank you
08-06-2009 10:16 AM
Predrag
As far as I know in your situation you need to perform password recovery to get into the router. After password recovery is done and you are in the router in enable mode you could load the startup config if you wish, or you can just start configuring the router from scratch.
I recently ran into a very similar situation where we had not created a new user iD and password, and the password recovery worked very well for us.
HTH
Rick
08-06-2009 11:28 PM
Thank you Rick very much, for advice. i will do that.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: