12-17-2012 03:41 PM - edited 03-04-2019 06:26 PM
Hello,
I encounter a problem that I am unable to resolve. So I was wondering if you guys can help me with it. I have a T1 and the ISP is ATT. So here is the config:
Old Configuration: Router 1: | Router 2: | |||
Cisco 2821 | Cisco 2821 | |||
HWIC-1DSU-T1 | HWIC-1DSU-T1 | |||
New Config. | ||||
Router 1: | Router 2: | |||
Cisco 2911 | Cisco 2911 | |||
VWIC3-2MFT-T1/E1 | HWIC-1DSU-T1 |
So when I replaced the routers, the T1 went down hard. I had ASI alarms I couldn't ping Router 2. I was able to get to Router 1 becuase P0 goes to other site and P1 goes to Router 2. So what I ended up doing is install HWIC-1DSU-T1 in Router 1 and I was able to ping Router 2. But I couldn't make Router 1 using the VWIC3-2MFT-T1/E1 to ping Router 2. I have similar configuration on other sites, where we use these the same models cards and routers.
Thanks in advance.
Solved! Go to Solution.
12-17-2012 04:57 PM
I doubt you'll get much help until you post some configs and some diagnostics.
Sent from Cisco Technical Support iPad App
12-17-2012 04:57 PM
I doubt you'll get much help until you post some configs and some diagnostics.
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide