- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-17-2012 03:41 PM - edited 03-04-2019 06:26 PM
Hello,
I encounter a problem that I am unable to resolve. So I was wondering if you guys can help me with it. I have a T1 and the ISP is ATT. So here is the config:
Old Configuration: Router 1: | Router 2: | |||
Cisco 2821 | Cisco 2821 | |||
HWIC-1DSU-T1 | HWIC-1DSU-T1 | |||
New Config. | ||||
Router 1: | Router 2: | |||
Cisco 2911 | Cisco 2911 | |||
VWIC3-2MFT-T1/E1 | HWIC-1DSU-T1 |
So when I replaced the routers, the T1 went down hard. I had ASI alarms I couldn't ping Router 2. I was able to get to Router 1 becuase P0 goes to other site and P1 goes to Router 2. So what I ended up doing is install HWIC-1DSU-T1 in Router 1 and I was able to ping Router 2. But I couldn't make Router 1 using the VWIC3-2MFT-T1/E1 to ping Router 2. I have similar configuration on other sites, where we use these the same models cards and routers.
Thanks in advance.
Solved! Go to Solution.
- Labels:
-
WAN
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-17-2012 04:57 PM
I doubt you'll get much help until you post some configs and some diagnostics.
Sent from Cisco Technical Support iPad App

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-17-2012 04:57 PM
I doubt you'll get much help until you post some configs and some diagnostics.
Sent from Cisco Technical Support iPad App
