05-24-2012 03:20 AM - edited 03-04-2019 04:27 PM
Hi,
I'm trying to get PXE booting working over a DMVPN link.
I'm currently at the point that the PC gets an IP address, and then tries the TFTP boot, but I get the message:
PXE-E32: TFTP open timeout
PXE-E32: TFTP open timeout
PXE-M0F: Exiting Intel Boot Agent.
The BVI1 interface is setup with 2 ip helper-addresses, 1 for the DHCP server, 1 for the TFTP/PXE server. Booting from PXE works fine at the main site.
The config of the DMVPN Spoke is attached.
I'm currently guessing this has something to do with MTU settings and TFTP, but I'm at a loss at the moment.
05-24-2012 10:17 AM
Check that you can TFTP using another PC.
07-17-2015 02:56 AM
Hi, did you resolve this? I'm experiencing the same issue and would appreciate any suggestions.
Thanks,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: