10-02-2017 12:33 PM - edited 03-05-2019 09:13 AM
I recently upgraded a Catalyst 3650 from 03.03.03 to 03.07.05 and the switch is no longer recognizing my radius setup. I've pulled some info and examples of what the commands are now, and confirmed my auth and acct ports on the NPS server. Nothing is working.
The NPS server (Windows 2012 R2) hasn't logged a single connection attempt since the upgrade.
Here are the radius lines from the switch:
aaa authentication login default group radius local
aaa authorization exec default group radius local
radius server default
address ipv4 10.10.10.61 auth-port 1812 acct-port 1813
key switch19nps
Many thanks in advance
Solved! Go to Solution.
10-03-2017 09:42 AM
10-02-2017 01:19 PM
10-03-2017 04:19 AM
Thanks for the suggestion, but unfortunately the command errored out at 'host'
GE-L3-07#ping 10.10.10.61
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.10.10.61, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/4/10 ms
GE-L3-07(config)#$.10.10.61 auth-port 1812 acct-port 1813 key switch19nps
radius-server host 10.10.10.61 auth-port 1812 acct-port 1813 key switch19nps
^
% Invalid input detected at '^' marker.
10-03-2017 09:42 AM
10-02-2017 02:00 PM
Hello,
default accounting port is UDP 1646, and default authentication port is UDP 1645, can you try those ?
You can also configure the 'automate tester' to test if the configure ports work at all....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide