read only rommon initialized

[bellaireroad]

I am trying to configure a 1941, but the router boots into readonly rommon . after configuring the router and  copy running config  to startup config, on reboot, none of the changes are saved, and boots back into readonly rommon.  any ideas what is going on? thanks

[Leo Laohoo · Accepted solution]

Your config registry is probably set to password-recovery.

In rommon, type the following command:

1.  confreg 0x2102

2.  boot

Please don't forget to rate our useful posts.  Thanks.

[bellaireroad]

thanks a bunch!!!!!!!!!!