I have a remote office that we connect with 2 bundled T1's.
We have recently had to move a department to this office (~25 users). We have VOIP setup as well.
Question- I never see any problems with bandwidth, the least amount available has always been around 2500K... but they still experience some latency with applications when connecting back to the corp office...
I do have QoS enabled on the routers with a priority of 512 for voice. The bundles are mapped with 1544 bandwidth each...?
The biggest issue right now is ms-access, I know its a hog to begin with- but why am i still seeing so much bandwidth being un-utilized on the bundle when reviewing through the SDM QoS monitor... as well as SDM interface -Multilink bandwidth usage.
heres a snippet of the serials:
interface Serial0/2/0
description first T1 line
bandwidth 1544
no ip address
encapsulation ppp
load-interval 30
ppp multilink
ppp multilink group 1
-pretty basic-
No errors on any interfaces with switch/or routers...
thoughts...? Can we force more bandwidth to be used-
Thanks
