03-09-2015 06:15 AM - edited 03-05-2019 12:58 AM
Hello
I did a vpn to vpn between two RV180 W. I can establise a connection but after a while in the two device i get IPsec SA Not Established
Could someone help me with this problem ?
Thanks for the answer
Best regards
gic
03-09-2015 10:50 AM
the isakmp session will time out if no traffic is going across the tunnel can you setup ip sla to send pings through the tunnel? this will keep it active.
03-10-2015 12:55 AM
thanks for your answer.
It's possible to do that in a cisco Rv180 W ?
03-10-2015 10:12 PM
Hi I am not sure does it have a console port or a web interface I willl research the device
03-16-2015 01:45 AM
Thanks for your answer.
I found the solution. Go to Firewall - Attack Prevention and disable Stealth Mode. My vpn tunnels keep alive.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: