05-06-2011 06:22 AM - edited 03-04-2019 12:17 PM
Hello All,
I have tried to restrict access to loopback interface using ACL's with no luck. Does anyone know how this can be done?
Thanks,
Ram
Solved! Go to Solution.
05-06-2011 06:27 AM
The loopback is a "special" interface.
To limit connectvity you should look into restricting via the Control Plane - BEWARE you break everything if configured incorrectly. Read the below VERY carefully.
http://www.cisco.com/en/US/docs/ios/sec_control_plane/configuration/guide/12_4t/cps_12_4t_book.html
HTH>
05-06-2011 06:27 AM
The loopback is a "special" interface.
To limit connectvity you should look into restricting via the Control Plane - BEWARE you break everything if configured incorrectly. Read the below VERY carefully.
http://www.cisco.com/en/US/docs/ios/sec_control_plane/configuration/guide/12_4t/cps_12_4t_book.html
HTH>
05-06-2011 06:52 AM
Andrew is correct.
Think "why" you're doing before doing it.
05-06-2011 09:07 AM
Thanks Andrew. I will try it
05-12-2011 05:21 AM
I used management plane protection and it works great!
control-plane host
management-interface FastEthernet4 allow ssh snmp
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: