cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
121
Views
0
Helpful
2
Replies
Beginner

Route-Maps on VLAN won't stay

Hi,

I can't figure out why my route-map won't stay on the VLAN? Even time I try to apply it to the VLAN and I do a show run the command isn't there? I don't receive any errors while  trying to issue the command. I have enabled SDM prefer routing and rebooted my switch. We are also running an IP services image. Any ideas?

interface Vlan92

ip address x.x.x.x 255.255.255.0

ip policy route-map PBR_CPK

ip access-list extended PBX_Monitoring

permit ip host x.x.x.x x.x.x.x 0.0.0.127

route-map PBR_CPK permit 10

match ip address PBX_Monitoring

set ip next-hop x.x.x.x

                  

Switch#sh sdm prefer
The current template is the routing template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1K VLANs.

number of unicast mac addresses:   5K
number of igmp groups:             1K
number of qos aces:                512
number of security aces:           512
number of unicast routes:          16K
number of multicast routes:        1K

!

System image file is "flash:c3550-ipservicesk9-mz.122-25.SEC2

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Route-Maps on VLAN won't stay

Hi Nicholas,

Please configure "sdm prefer extended-match" and then check.

Regards,

Subeh

View solution in original post

2 REPLIES 2
Highlighted
Beginner

Route-Maps on VLAN won't stay

Hi Nicholas,

Please configure "sdm prefer extended-match" and then check.

Regards,

Subeh

View solution in original post

Highlighted
Beginner

Re: Route-Maps on VLAN won't stay

Hi Subeh Sharma

Could you please explaim why extended match will work vs routing? Do you have a document explaining the differences of the two SDM?