I can't figure out why my route-map won't stay on the VLAN? Even time I try to apply it to the VLAN and I do a show run the command isn't there? I don't receive any errors while trying to issue the command. I have enabled SDM prefer routing and rebooted my switch. We are also running an IP services image. Any ideas?
ip address x.x.x.x 255.255.255.0
ip policy route-map PBR_CPK
ip access-list extended PBX_Monitoring
permit ip host x.x.x.x x.x.x.x 0.0.0.127
route-map PBR_CPK permit 10
match ip address PBX_Monitoring
set ip next-hop x.x.x.x
Switch#sh sdm prefer
The current template is the routing template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1K VLANs.
number of unicast mac addresses: 5K
number of igmp groups: 1K
number of qos aces: 512
number of security aces: 512
number of unicast routes: 16K
number of multicast routes: 1K
System image file is "flash:c3550-ipservicesk9-mz.122-25.SEC2
Solved! Go to Solution.
Hi Subeh Sharma
Could you please explaim why extended match will work vs routing? Do you have a document explaining the differences of the two SDM?