cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
485
Views
0
Helpful
1
Replies

route redistribution with route map is not obeying the route map...Nexus OS 7

suelange
Level 1
Level 1

I need to redistribute some OSPF routes into EIGRP.  pretty simple.  But I built a filter (for testing basically) to limit what routes get put in.  Like so:

ip access-list test-distrib-ospf-to-eigrp
10 permit ip 10.120.32.0/24 any
route-map ospf-to-eigrp permit 10
match ip address test-distrib-ospf-to-eigrp

 

when I did the redistribution from ospf to eigp:

router eigrp 1
router-id 10.4.199.2
default-metric 1000 30 255 1 1500
redistribute ospf 1 route-map ospf-to-eigrp

 

it ignored my route map and redistributed everything from ospf into eigrp. 

 

the spelling of the names of the ACL and the route map are matching...so what did I do wrong?

 

I read one article where it stated that the route map doesn't pay attention to the prefix length but...I've got PBR using specific (/32) addresses to reroute specific traffic, and that works just fine.  So what did I do wrong here?

1 Accepted Solution

Accepted Solutions

suelange
Level 1
Level 1

actually I may have just found my problem...ip prefix list would be a better choice than an ACL like we would have used on a router or even 3850...testng now...

View solution in original post

1 Reply 1

suelange
Level 1
Level 1

actually I may have just found my problem...ip prefix list would be a better choice than an ACL like we would have used on a router or even 3850...testng now...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card