cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
296
Views
0
Helpful
1
Replies

Route traffic from inbound switchport toward outbound L3 interface

I am wondering if this is possible. I was trying with policy based routing, but I think I was barking up the wrong tree. We have a 3925 router. For a specific subnet, all traffic comes in to g0/1/1 (switchport). I need to force it to exit G0/2 (L3 interface). As I said, I tried PBR, but the 'ip policy' command is not available on g0/1/1. Very green admin here. Any ideas? Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Re: Route traffic from inbound switchport toward outbound L3 interface

It is as expected.  PBR is a feature for layer 3 interface.  Instead applying your PBR on g0/1/1, you can apply it to your SVI interface.  

1 REPLY 1
Highlighted

Re: Route traffic from inbound switchport toward outbound L3 interface

It is as expected.  PBR is a feature for layer 3 interface.  Instead applying your PBR on g0/1/1, you can apply it to your SVI interface.  

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards


This widget could not be displayed.