cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1111
Views
0
Helpful
4
Replies

Router 1841 don´t charge

PEDRO AGUILAR
Level 1
Level 1

I have a problem with a router 1841 because a student erase the cisco ios, but, don´t charge the rommon, only see symbols when i use the console cable,

thanks for your help.

i see this simbols: router error.JPG

1 Accepted Solution

Accepted Solutions

riadh1982
Level 1
Level 1

héllo

try changeing the baud rate in hyperterminal to different values (9600 default, try 115200)

i have faced similar problem when student put a  not-classic conf-reg,

bye

View solution in original post

4 Replies 4

russell.turner
Level 1
Level 1

The settings in the Hyper Terminal need to be set correctly; otherwise, "strange-looking" or garbage characters may show up on the screen. When you set up the connection, use these settings:

Bits per sec    :  9600 
Data bits       :     8 
Parity          :  none 
Stop bits       :     1 
Flow control    :  none 

riadh1982
Level 1
Level 1

héllo

try changeing the baud rate in hyperterminal to different values (9600 default, try 115200)

i have faced similar problem when student put a  not-classic conf-reg,

bye

Right-o.  Go back into ROMmon (by removing the CF and booting the router without the CF) and type the command "unset BAUD".  Make sure the "BAUD" is in all caps the "unset" is in lower caps (use Notepad).  Once this is done, reboot the router.  Make sure you give the student an "F" or something.    He he he ...

thank´s it works with a baund of 57600.

Review Cisco Networking for a $25 gift card