cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1018
Views
5
Helpful
2
Replies

Router 2821 problem with card Hwic-D-9ESW

rechard_david
Beginner
Beginner

Dear All,

I have some issue on Card Hwic-D-9ESW with Router 2821, i was install card 9ESW in to router 2821 on slot 2 and 3,

after i show run, the Cisco Router 2821 have interface F0/3/0 - F0/3/8.and i configure Vlan already  and interface up also.

when i connect PC to port F0/3/0, the interfface is up, but i cannot pint go interface, i mean it request time out.

my question is, Is it correct that i install card into slot 2 and 3?

what is the problem all port up but i cannot ping to interface?

Note: the same Vlan

Best regards,

Rechard

2 REPLIES 2

spremkumar
Engager
Engager

Hi

The ip which you are trying to ping is part of the same vlan which you configured on those ethernet interface?

can you post the config of the router here?

regds

mlund
Rising star
Rising star

Hi Rechard

It sounds that You have installed 2 modules, one in slot 2 and one in slot 3.

If this is the case, You have to connect these two modules with a crossovercable.

You also have to configure "stacking partner" to get it to work. see this link

http://www.cisco.com/en/US/docs/ios/lanswitch/configuration/guide/lsw_hwic_ethsw_ic_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1049119

/Mikael

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: