01-24-2011 07:35 PM - edited 03-04-2019 11:11 AM
Dear All,
I have some issue on Card Hwic-D-9ESW with Router 2821, i was install card 9ESW in to router 2821 on slot 2 and 3,
after i show run, the Cisco Router 2821 have interface F0/3/0 - F0/3/8.and i configure Vlan already and interface up also.
when i connect PC to port F0/3/0, the interfface is up, but i cannot pint go interface, i mean it request time out.
my question is, Is it correct that i install card into slot 2 and 3?
what is the problem all port up but i cannot ping to interface?
Note: the same Vlan
Best regards,
Rechard
01-25-2011 02:13 AM
Hi
The ip which you are trying to ping is part of the same vlan which you configured on those ethernet interface?
can you post the config of the router here?
regds
01-25-2011 04:30 AM
Hi Rechard
It sounds that You have installed 2 modules, one in slot 2 and one in slot 3.
If this is the case, You have to connect these two modules with a crossovercable.
You also have to configure "stacking partner" to get it to work. see this link
/Mikael
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: