cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
959
Views
5
Helpful
4
Replies

Router 4321

MAGagnon
Level 1
Level 1

Hello
I just bought a 4321 router to replace my RV042. By connecting on the router I realized (with horror) that the configuration is done by CLI, I thought I was back in the 80s. I am not a
routers specialist but I understand what they do how do basic configuration.

Is it possible to have a visual version to configure the router like what I had for the RV042?

4 Replies 4

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello

>> that the configuration is done by CLI, I thought I was back in the 80s

So I have been in the 80s in last 22 years and I didn't know. Thanks for this moment of LOL !

 

Some sort of Cisco Network Assistant or Cisco Professional GUI should be available to perform basic setup.

 

Edit

I apologize the question is not trivial at all.

the Cisco Professional is in end of sale

https://www.cisco.com/c/en/us/products/collateral/cloud-systems-management/configuration-professional/data_sheet_c78_462210.html

 

Cisco Network Assistant is described here

https://www.cisco.com/c/en/us/support/cloud-systems-management/network-assistant-version-6-0/model.html

 

Best Regards

Giuseppe

 

Hello,

 

the GUI is available, you just have to add a few things to the configuration to enable it:

 

Configuring Web User Interface Access

 

http://www.cisco.com/c/en/us/td/docs/routers/access/4400/software/configuration/guide/isr4400swcfg/bm_isr_4400_sw_config_guide_chapter_011.html#task_AEE38B2E6B5A4971AFB1C06BA8382695

Leo Laohoo
Hall of Fame
Hall of Fame
GUI is available if the IOS was loaded in Install Mode.

Thanks for the answer, How i load the IOS ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: