cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2460
Views
35
Helpful
17
Replies

Routing

ccrank
Level 1
Level 1
 
 
 

Hello All,

 

I am new to networking and I'm sure that will be apparent by this question. In one of my classes we have been asked to put together this network(see attached). I have connected everything and assigned IP addresses. I have a server and two computers all using different gateways on the router.

 

I don't understand how I am supposed to make all of these reachable without a switch. Any hints?

 

PC1_TestNetwork
NIC1
192.168.1.101
255.255.255.0
192.168.1.100
PC2_TestNetwork
NIC1
192.168.2.101
255.255.255.0
192.168.2.100
Server_TestNetwork
NIC1
192.168.3.101
255.255.255.0
192.168.3.100
Router_TestNetwork
FastEthernet0/0
FastEthernet0/1
FastEthernet1/0
192.168.1.100
192.168.2.100
192.168.3.100
255.255.255.0
n/a

 

Thanks for any advice,

Chris

17 Replies 17

balaji.bandi
Hall of Fame
Hall of Fame

not sure what is the router image version using here.

 

can you post-show version and show run from the router.

 

try below tip 

no cef - old one has some bugs.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

 

 Sorry I have no choice except to use screenshots. I should try the same setup in packet tracer.

The server has the correct ip address and gateway, but the two computers keep using 169(apipa)

 

I'm confused

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: