Routing

[calebstepp25]

 

Can anyone give me the configuration for this lab trying it at home on what the whole confit would be?

[Flavio Miranda]

Hi

 Which devices do you have? I mean, model and version?

[calebstepp25]

No version or model type just a home lab with the two switches and 1 router

[calebstepp25]

Just what would the config be for Router1. Switch 1 and switch 2

[Flavio Miranda]

The config may vary depending on the device model and version

 It is a lot of config so,  give this information and I help you.

[calebstepp25]

Both switches are Cisco catalyst 9400 series and the router is a Cisco 7200
series

[Flavio Miranda]

Start by adding IP address on each interface. If you did not yet.

If you did, put the interface between switches  in trunk

Int giga/fast x/x

 Switchport trunk

For router, you can configure the ospf with

router ospf 100

 Network x.x.x.x x.x.x.x area 0

Do it and let me know.