cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
527
Views
0
Helpful
2
Replies

RSP720-3C-GE SUP ENGINE REBOOT AUTOMATICALLY

maddyguru8525
Level 1
Level 1

RSP720-3C-GE .Hot Standby - Supervisor Module reboots Continuously in Cisco 7609-S  router and there is no crash info messages in slave-sup-boot-disk.

i have done troubleshooting 

1. Active/standby image version same

2.checked Active sup engine slot 5 and standby sup engine slot 6 respectively inserted the same.

3.re insert standby sup engine 

4. restart the router 

5. checked physical part on the slot - fine.

facing the issue automatically reboot standby sup engine.

2 Replies 2

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello ,

to understand if the issue is on the standby supervisor or on the C7600S chassis you would need a maintenance window of two hours:

you power off the chassis and swap supervisors in slot 5 and slot 6

You then power on the chassis and look at the results:

I see four possible cases:

a) the supervisor now in slot5 keeps rebooting --> the issue is on the supervior --> open an RMA for it

b) the supervisor now in slot 5 is stable, but the supervisor in slot6 keeps rebooting ---> the issue is on the chassis it is rare but it can happen

c) both swapped supervisors are stable.  At this point I would swap again after a power cycle.

d) both swapped supervisors are not stable.

 

What about power usage in the chassis? there is enough power for all linecards and the supervisors ?

 

Hope to help

Giuseppe

 

Thank you somuch. I will check and get back you. probabaly i will go with RMA,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco