Rv042 - VPN Tunnel stops passing traffic even though it says it's connected
I have a 12 site radio trunking system that relies on the internet for data/voice backhaul. Most sites use a cellular modem for internet and all have RV042's for VPN. Each router has a tunnel for each site. So each one has at least 12 VPN connections.
The system as a whole works fine, but occasionally data will not pass from one site to another even though the tunnel says it's connected. I have to hit the 'Disconnect' button to reset the tunnel and then it starts working again. I have Keep Alive and Dead Peer Detection (10 secs) enabled.
The only way I can tell if a tunnel is down (other than a customer complaining) is to do a site connection test through my radio management software. Right now I am forced to test it at least once or twice a day as at least 1 or 2 tunnels won't be working. And it's never the same tunnels; it seems to be completely random.
At this point I'm not sure what I can do to improve the reliability of the system. So I'm hoping someone can help me out here.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...