Showing results for 
Search instead for 
Did you mean: 

RV320 no Internet Connection


Hi All,

I am new to the forum.

I have recently purchased a Cisco RV320 and am having some issues with getting the WAN / Internet connectivity setup on this device.

My current setup is being used to test an implementation of this router, so I need to get my head around what the router is trying to do in order to replicate this when I install it in it's production environment.

Currently, I have a home office modem / router (Linksys XAC1900) which gives my home network an active internet connection (IP:, connection type is PPPoE)

I have connected the RV320 from one of the LAN ports on here into the primary WAN port on the RV320.

The RV320 has been setup with 3 x VLANs (require for separation of devices when it is connected to its production enviroment) It has been assigned the following IPs;
VLAN 1: 192.168.1.X
VLAN 2: 192.168.2.X
VLAN 3: 192.168.3.X

I have the inter-LAn connectivity working whereby I can ping the router (RV320) from each VLAN, which is fine. None of these VLANs are however receiving an Internet connection from my home modem / router.

When checking the System Summary page of the RV320 the Internet / WAN port is showing "Connected (Inactive)".

I am not 100% sure what the WAN Connection type should be as the Linksys has already connected to the ISP and is routing fine on my local network, so would I just use the "Obain IP Automatically" from the Basic Setup Wizard for the WAN connection?

Any assistance someone could provide would be greatly appreciated, I have had this router for approx two weeks and my deadline is looming and I still cannot work out how to get the RV320 to get an internet connection from my Linksys XAC1900.

1 Reply 1


I have this problem also

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: