RV340 with German Telekom IPTV and Multi-WAN - some questions ahead
I own a small business and got a 2nd ISP.
I have a RV340 up and running:
WAN1 - VDSL (modem in bridge mode) PPPoE (175mb/s) WAN2 - Cable with static IP (1000mb/s) Load-balancing is set to WAN2 80%, WAN1 20%
I added VLAN11 on eth3 for IPTV with dhcp server 192.168.11.0/24
I want WAN1 to get all incoming and outgoing traffic from VLAN11 and since the streams are multicast, I have to setup the IGMP proxy right. I tried the policy based routing but I can't find the right settings. Is the RV340 capable of IGMPv3?
Re: RV340 with German Telekom IPTV and Multi-WAN - some questions ahead
I don't think the RV340 supports IGMPv3, there is no option to select any IGMP version. The RV340 has only a few commands available through the CLI. You need a router with a full IOS in order to configure IGMP version 3...
Is your WAN ready for a multicloud transformation?
Network Insider Live Webinar
Tuesday, July 21, 2020 10:00 am Pacific Time (San Francisco, GMT-08:00)
This webinar will show how convergence between SD-WAN and Security is emerging as important new SASE a...
Does anyone know if perpetual PoE is supported on C2960XR-24PD-I? (currently running15.2(7)E2)I get error when trying to configure perpetual PoE on any of the ports. switch(config-if)#power inline port perpetpual-poe-ha  ...
We are having issues with a WS-C2960X-48FPD-L running IOS 15.2(2)E7. Some ports are simply not working. We had POE issues on some https://showbox.bio/ https://tutuapp.uno/ https://vidmate.cool/ of the ports and decided to upgrad...
Inviting all network professionals! We'd like to understand IT priorities for your organization and the time taken for key network management activities. Your response will help us provide you insights on OpEx, provisioning, and troubleshooting savings w...
Hi! I have a 3945 series router and if there is a power loss, or the router is rebooted, it loses controller, and WAN interface serial configuration. Any thoughts on what may be causing this? The confreg-register is at 0x2102 which is the correct setting....