Hey guys, Im trying to setup a lab at my house and I bought two 2600 routers that came with T1 wics.
I have made a T1 crossover cable but cant seem to get any traffic to flow, here are the commands I ran:
TOP#configure terminal
TOP(config)#interface s0/0
TOP(config-if)#service-module t1 clock source internal
TOP(config-if)#service-module t1 framing esf
TOP(config-if)#service-module t1 linecode b8zs
TOP(config-if)#service-module t1 timeslots 1-24 speed 64
TOP(config-if)#encapsulation ppp
TOP(config-if)#ip address 192.168.1.2 255.255.255.0
TOP(config-if)#no shutdown
BOTTOM#configure terminal
BOTTOM(config)#interface s0/0
BOTTOM(config-if)#service-module t1 clock source line
BOTTOM(config-if)#service-module t1 framing esf
BOTTOM(config-if)#service-module t1 linecode b8zs
BOTTOM(config-if)#service-module t1 timeslots 1-24 speed 64
BOTTOM(config-if)#encapsulation ppp
BOTTOM(config-if)#ip address 192.168.1.1 255.255.255.0
BOTTOM(config-if)#no shutdown
I get a green link light and the alarm light is soild amber. Any help would be much apreicated!