cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
556
Views
0
Helpful
2
Replies

show ip cef summary (english translation)

merryllem
Level 1
Level 1

Greetings all,

Like the subject says I need an english translation of the following output. :) (Spefically the "load sharing elements" line)

ROUTER A OUTPUT

IP CEF with switching (Table Version 73), flags=0x0

23 routes, 0 reresolve, 0 unresolved (0 old, 0 new), peak 1

5 instant recursive resolutions, 0 used background process

1 load sharing elements, 1 references

8 in-place/0 aborted modifications

26780 bytes allocated to the FIB table data structures

universal per-destination load sharing algorithm, id BA9D2B35

1(0) CEF resets

Resolution Timer: Exponential (currently 1s, peak 1s)

Tree summary:

8-8-8-8 stride pattern

short mask protection disabled

23 leaves, 20 nodes using 23084 bytes

Table epoch: 0 (23 entries at this epoch)

ROUTER B OUTPUT

IP CEF with switching (Table Version 71), flags=0x0

22 routes, 0 reresolve, 0 unresolved (0 old, 0 new), peak 1

1 instant recursive resolution, 0 used background process

2 load sharing elements, 2 references

17 in-place/0 aborted modifications

27148 bytes allocated to the FIB table data structures

tunnel per-destination load sharing algorithm, id 818781A0

1(0) CEF resets

Resolution Timer: Exponential (currently 1s, peak 1s)

Tree summary:

8-8-8-8 stride pattern

short mask protection disabled

22 leaves, 20 nodes using 23056 bytes

Table epoch: 0 (22 entries at this epoch)

Thanks in advance

2 Replies 2

purohit_810
Level 5
Level 5

Hi,

For this specific scenario, the hash function for the load-sharing algorithm is biased toward serial 0/0. You need to "reseed" the algorithm and to get balanced traffic mix across the two links, You can see more in detail " ip cef load-sharing algorithm universal "

Thanks,

Dharmesh Purohit

Thanks Dharmesh for the reply. I was able to figure out why the outputs were different. Turns out I was missing some routes in the routing table. Therefore cef did not see the "other" adjancent path to the destination. Anyways the real reason why opened a topic is because some cef load-balancing im currently having. I will open new topic for that shortly. again Thanks.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card