The Door release is a
Zenitel IPSTATION v2.0 ( on the web page it is called a Turbine IP-stationWeb)
All teh documentation is for a call manager, not a call manager express.
I cannot get the door bell button to ring the reception, the button does nothing.
I am sure the Zenitel IPSTATION v2.0 is configureed correctly
here is the confog on the CME:
voice register dn 40
number 4040
voice register pool 8
id mac 0013.CB06.1FF7
number 1 dn 40
dtmf-relay rtp-nte
username 4040 password 4040
Here is the Show output, as you can see it is registered.
Zenitel IPSTATION v2.0
sh voice register pool 8
Pool Tag 8
Config:
Mac address is 0013.CB06.1FF7
Number list 1 : DN 40
Proxy Ip address is 0.0.0.0
Current Phone load version is Zenitel IPSTATION v2.0
DTMF Relay is disabled
Call Waiting is enabled
DnD is disabled
Video is disabled
Camera is disabled
Busy trigger per button value is 0
keep-conference is enabled
registration expires timer max is 3600 and min is 1800
username 4040 password 4040
Lpcor Type is none
Transport type is udp
service-control mechanism is not supported
registration Call ID is 1544401931@10.42.31.10
Registration method: per line
Privacy feature is not configured.
Privacy button is disabled
active primary line is: 4040
contact IP address: 10.42.31.10 port 5060
conference admin: no
conference add mode: all
conference drop mode: never
paging-dn: config 0 [multicast] effective 0 [multicast]
Dialpeers created:
Dial-peers for Pool 8:
dial-peer voice 40013 voip
destination-pattern 4040$
session target ipv4:10.42.31.10:5060
session protocol sipv2
after-hours-exempt FALSE
Statistics:
Active registrations : 1
Total SIP phones registered: 19
Total Registration Statistics
Registration requests : 349
Registration success : 349
Registration failed : 0
unRegister requests : 348
unRegister success : 348
unRegister failed : 0
Attempts to register
after last unregister : 0
Last register request time : 08:00:39.549 GMT Tue Dec 24 2013
Last unregister request time : 08:05:43.406 GMT Tue Dec 24 2013
Register success time : 08:00:39.549 GMT Tue Dec 24 2013
Unregister success time : 08:05:43.406 GMT Tue Dec 24 2013
The when I call the intercom - it beeps Just once.
Also when pressing the botton on the front - it is set to Dial reception on 6800, but the phone never rings.
Does anyone know of some good debugs to troubleshoot this - or has worked with these two pieces of hardware before?
