cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
223
Views
1
Helpful
1
Replies

Site Recovery with site A and site B network isolated

Neetu Bhushan
Level 1
Level 1

Hi All,

I'm planning site recovery with my protected server.  It mention that i need to have my site A and site B server network to be isolated to each other so that it will not create error on my site A network (because it's the same network and subnet).  But how do I make my site B server network available to my site A users when site A disaster happened.  Do I have to modify the routing when it happened.  How do i make it automatic?  What's the best routing for it (ospf or eigrp or others)?

Thanks for any comment you may add.

1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

Hi Rob,

You can change one of the site's ip address segment and than run OSPF between your 2 sites. It will be all dynamic. If your 2 sites are small, you can put all your routers in the same OSPF area (area 0).

HTH

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco