cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
145
Views
0
Helpful
3
Replies
Highlighted

SNMP Related Services

Can we use the Mgmt port (int GigabitEthernet 0) SNMP without removing the existing Interface.??

 

 

Router(config)# snmp-server view myview mib-2 included
Router(config)# snmp-server trap link ietf
Router(config)# snmp-server trap-source GigabitEthernet0/0/0

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Master

Re: SNMP Related Services

Hello @ehtesham.ahmed1 ,

 

>> we need both interface in SNMP… int Gi0/0/0 and int Gig0

 

I'm afraid this is not supported as the purpose of the command is to use a single source address when sending SNMP packets in order to make easier the device identification on the management servers.

This is why the second instance of the command overwrites the previous one.

 

Hope to help

Giuseppe

 

View solution in original post

3 REPLIES 3
Highlighted
VIP Engager

Re: SNMP Related Services

 

 - That should work

 M.

Highlighted

Re: SNMP Related Services

Yes, Its work.



When giving to command in SMNP, it will remove the existing int gi0/0/0.



Only accept one interface in SNMP ..



we need both interface in SNMP… int Gi0/0/0 and int Gig0


Highlighted
Hall of Fame Master

Re: SNMP Related Services

Hello @ehtesham.ahmed1 ,

 

>> we need both interface in SNMP… int Gi0/0/0 and int Gig0

 

I'm afraid this is not supported as the purpose of the command is to use a single source address when sending SNMP packets in order to make easier the device identification on the management servers.

This is why the second instance of the command overwrites the previous one.

 

Hope to help

Giuseppe

 

View solution in original post