Static nat

[ziziahmed9]

Hy everyone 

Please I have problem with cisco router

I configured static nat on router , when I run show ip nat transactions,  the internal and external addresses that I configure appear but when capture packets outside the source ip doesn't translated ?

Thank

[ziziahmed9]

Ok thank you very much.  I will check

[ziziahmed9]

Unfortunately , the problem persists when I capture icmp packet in interface that I ping , I find that address hasn't been translated 

[ziziahmed9]

Is there other suggestion to resolve this problem?

[MHM Cisco World]

there are many types of NAT and these type can work simultaneous AND some not work 
NAT 1:1 using One IP outside interface can not work with dynamic NAT using same interface <<- this I think your case 
PAT 1:1 using port NATing to one IP outside interface can work with dynamic NAT using same interface

solution I think 
ip nat inside source static icmp <ip><ip>
ip nat inside source list 1 interface <x> overload  

[ziziahmed9]

Should I remove dynamic NAT configs?

[paul driver]

Hello
If your static nat is not working, did you ammed the NAT ACL ( as I suggested) to deny that host from being dynamically translated?

[ziziahmed9]

Me when I use static NAT I remove all configurations that are related with dynamic NAT.