05-26-2015 06:23 PM - edited 03-05-2019 01:33 AM
Does Static routing support load balancing? how will you configure?
05-26-2015 08:15 PM
Hi,
Yes, static routing does support load balancing, refer the below thread for config assistance.
https://supportforums.cisco.com/discussion/11665226/static-route-load-balancing
http://www.brocade.com/downloads/documents/html_product_manuals/FI_08010_L3/GUID-01C97118-4521-4599-8ACD-134E7FD30124.html
Regards,
Venkatesh
05-26-2015 08:16 PM
Hi,
Yes, it is possible to use load balancing with static routes. In fact, it does not depend on the type of routes, whether they are static or learned from a dynamic routing protocol, as the load balancing is a function of using the routing table, not populating it.
You would simply configure multiple static routes to the same destination with different next hop addresses or different egress interfaces (applicable only if the interface is a point-to-point technology like PPP, HDLC, simple GRE tunnel, etc.). As a result, the routing table will contain multiple paths to the same destination, and the router will perform load balancing automatically.
Best regards,
Peter
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: