Hi all,
I have the following router 7500:
sh ver
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-ISV-M), Version 12.0(9), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Mon 24-Jan-00 22:58 by bettyl
Image text-base: 0x60010930, data-base: 0x60C30000
ROM: System Bootstrap, Version 11.1(2) [nitin 2], RELEASE SOFTWARE (fc1)
BOOTFLASH: GS Software (RSP-BOOT-M), Version 11.1(8)CA1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
Nisa7500 uptime is 2 weeks, 23 hours, 37 minutes
System restarted by processor memory parity error at PC 0x60262A38, address 0x0 at 19:27:24 UTC Mon May 22 2006
System image file is "slot0:rsp-isv-mz.120-9"
cisco RSP2 (R4700) processor with 131072K/2072K bytes of memory.
R4700 processor, Implementation 33, Revision 1.0
Last reset from power-on
G.703/E1 software, Version 1.0.
G.703/JT2 software, Version 1.0.
X.25 software, Version 3.0.0.
Bridging software.
Chassis Interface.
1 VIP2 R5K controller (2 FastEthernet)(1 POS).
2 FastEthernet/IEEE 802.3 interface(s)
1 Packet over SONET network interface(s)
123K bytes of non-volatile configuration memory.
16384K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
No slave installed in slot 3.
Configuration register is 0x2102
and I have CEF enabled in all interfaces.
I want to transmit through the POS (STM1) interface more than 100Mbps but when I try to transmit more than 80Mbps I can see that the delays over this link are much greater.
I issued:
sh int pos 1/0/0
POS1/0/0 is up, line protocol is up
Hardware is cyBus Packet over Sonet
MTU 4470 bytes, BW 155000 Kbit, DLY 100 usec, rely 255/255, load 69/255
Encapsulation PPP, crc 32, loopback not set, keepalive set (10 sec)
Scramble enabled
LCP Open
Open: IPCP, CDPCP
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 1d04h
Queueing strategy: fifo
Output queue 0/40, 38 drops; input queue 1/1500, 0 drops
5 minute input rate 30336000 bits/sec, 7527 packets/sec
5 minute output rate 41960000 bits/sec, 6986 packets/sec
802366763 packets input, 4006294907 bytes, 5091 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 2090834 ignored, 0 abort
683603799 packets output, 4173775391 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
and I can see that there are a lot of "ignored".
Is this possible that VIP or PA is not able to handle incoming packets?
What could be the solution?
Thanks a lot in advance.
Regards.
Rubén.
