We have a router (7206) which connected to client device in /30 IP segment, but this device is a switch which connected to many more devices.
Doing packet capture on our router interface unravel many ARP requests whcih comes from the client switch.
Is there any feature or command which we can stop this?
If you want to limit arp request on switch you may go through below link.
It helps you to configure maximum number of mac-address per physical port.
Just for more insight Can you show topology for one customer. Is it like 7206-----Trunk----Switch----Customers ?
Regards # Mahesh
He is facing the arp on router interface not on switch which is clint side..
Sent from Cisco Technical Support iPhone App