Storm Control

[IrfanKhan4904]

Our Core Switch is Cisco 3650.How should storm control be configured on this device? If configured, will it have any negative impact on the network, and should it be implemented on all switches?

[MHM Cisco World · Accepted solution]

first check this link 
https://netcraftsmen.com/understanding-cisco-traffic-storm-control/
you can apply it to trunk between SW
how can decide which level I need

[IrfanKhan4904]

CCTV camera connected with switch port int gig 0/2.So i want to control storm control.Can you guide me how i can configure ?

[IrfanKhan4904]

Faculty-Block-5#show storm-control bro
Faculty-Block-5#show storm-control broadcast
Key: U - Unicast, B - Broadcast, M - Multicast
Interface Filter State Upper Lower Current Action Type
--------- ------------- ----------- ----------- ---------- --------- ----
Gi1/0/9 Forwarding 50.00% 50.00% 0.00% None B

[MHM Cisco World]

first check the more note but this time for Cisco TAC 
friend there is no specific level, it depend on your network. 
but let say as start point make level 20 for uni/multi/broadcast 
MHM