cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1264
Views
0
Helpful
1
Replies

Substitute for GRE Tunnel on 3560

jeremy.gould
Level 1
Level 1

Newbie question here...

So I've been tasked with replacing an old 2811 router with a 3560 at a WAN site. This is connected from the existing 2811 back through a Gigaman telco circuit with a few different handoffs back to my core with a 3550. In the past, we used a GRE tunnel to ensure that multicast was working correctly.

I want to implement VRFs as well (but that might be a different animal), so I'm not sure how to go about doing this. As I just found out, our 3560 is at over software revision 3.3 where GRE functionality was removed.

Is there a good substitute way to make this work? Or am I going about this the wrong way? I'm fairly new and not sure where to go from here.

Thanks,

Jeremy

1 Accepted Solution

Accepted Solutions

keglass
Level 7
Level 7

Hi, Jeremy,

I recommend you also post this question to the Cisco Support Community for additional information and feedback.

https://supportforums.cisco.com/

I hope this helps. Thank you for participating in the community.

Kelli Glass

Moderator for Cisco Customer Communities

View solution in original post

1 Reply 1

keglass
Level 7
Level 7

Hi, Jeremy,

I recommend you also post this question to the Cisco Support Community for additional information and feedback.

https://supportforums.cisco.com/

I hope this helps. Thank you for participating in the community.

Kelli Glass

Moderator for Cisco Customer Communities

Review Cisco Networking for a $25 gift card