06-27-2019 12:33 PM
Configure and install a summary route on R01 to allow PC1 to reach all networks on R02, R03, & R04
Solved! Go to Solution.
06-27-2019 01:52 PM
Hello,
R01
interface Serial0/0/0
ip address 1.55.1.1 255.255.255.252
!
interface GigabitEthernet0/1
ip address 10.10.55.1 255.255.255.240
R02
interface Serial0/0/0
ip address 1.55.1.2 255.255.255.252
!
interface GigabitEthernet0/0
ip address 10.55.20.1 255.255.255.0
!
interface GigabitEthernet0/1
ip address 10.55.22.1 255.255.255.0
R03
interface GigabitEthernet0/0
ip address 10.55.22.2 255.255.255.0
!
interface Loopback1
ip address 10.55.23.1 255.255.255.0
R04
interface GigabitEthernet0/0
ip address 10.55.20.2 255.255.255.0
!
interface Loopback1
ip address 10.55.21.1 255.255.255.0
06-27-2019 12:43 PM
Hello,
what is your question ? The summary route is in your screen capture. If you need a static route:
R01#conf t
R01(config)#ip route 10.55.20.0 0.0.3.255 10.55.1.2 <-- this needs to be the IP address of interface Serial0/0/0 on R02
Or are you supposed to use a routing (which) protocol ?
06-27-2019 01:35 PM
am trying to figure what will be the ip for each routers from R1 TO R4
06-27-2019 01:52 PM
Hello,
R01
interface Serial0/0/0
ip address 1.55.1.1 255.255.255.252
!
interface GigabitEthernet0/1
ip address 10.10.55.1 255.255.255.240
R02
interface Serial0/0/0
ip address 1.55.1.2 255.255.255.252
!
interface GigabitEthernet0/0
ip address 10.55.20.1 255.255.255.0
!
interface GigabitEthernet0/1
ip address 10.55.22.1 255.255.255.0
R03
interface GigabitEthernet0/0
ip address 10.55.22.2 255.255.255.0
!
interface Loopback1
ip address 10.55.23.1 255.255.255.0
R04
interface GigabitEthernet0/0
ip address 10.55.20.2 255.255.255.0
!
interface Loopback1
ip address 10.55.21.1 255.255.255.0
06-27-2019 03:15 PM
06-27-2019 03:18 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide