I have a SUP2-MSFC2 that once I boot it up, the Status and System LED's go straight to red and the Switch Load shows 2 "bars" and hangs there. I get no console output.
Now this is in a 6509 chassis with a 2500watt power supply. I took off the MSFC2 and it still does it with just the SUP2 part. I also changed the memory and bootflash with no change. This is a "known working" SUP. I have tested 5 of these sups in two days using this same chassis, memory type, etc. So It must be something with the SUP2. Anyone come across this issue, and know what to do?
In order to switch the console connection physically to the MSFC on the active Supervisor Engine, use the switch console [Module Number] command. If it will not work try work out with different chassis. Can you please send me the show mod
Introduction to Routing ProtocolsStatic vs DynamicDistance Vector vs Link StateRoute Selection AlgorithmSingle Routing Protocol OnlyOpen Shortest Path First (OSPF)AreasRoute ConvergencePath SelectionMetric CalculationCharacteristicsEnhanced Interior Gatew...
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.
Listen: https://smarturl.it/CCRS8E46Follow us: twitter.com/ciscochampionsIt’s been several years since the release of Cisco DNA Center, and it’s matured into a complete network management system, an automation and orchestration engine, an AI/ML analy...