I want to implement port security on one of the fastethernet ports on a Cisco 887VAG but the switchport port-security command is not available.
All i want is to bind a mac address to fastethernet 0, the only command that looks relevant is the 'switchport protected'.
Whats the best way to do this?
no ip address
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
priority Set 802.1p priorities
protected Configure an interface to be a protected port
trunk Set trunking characteristics of the interface
voice Voice appliance attributes
Mac based acl feature doesnt exist
Yes it does. Below is taken from my cheap 891 router:
Router(config)#access-list 700 permit ?
H.H.H 48-bit hardware address
Yes you can configure a MAC ACL but can you bind it to a L2 interface ?
And if you can will it behave like on most switches that is only filter non IP traffic which in this case won't solve the OP problem ?
Don't forget to rate helpful posts.