11-25-2013 05:20 AM - edited 03-04-2019 09:40 PM
I want to implement port security on one of the fastethernet ports on a Cisco 887VAG but the switchport port-security command is not available.
All i want is to bind a mac address to fastethernet 0, the only command that looks relevant is the 'switchport protected'.
Whats the best way to do this?
interface FastEthernet0
description Printer
no ip address
end
router-new(config-if)#switchport ?
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
priority Set 802.1p priorities
protected Configure an interface to be a protected port
trunk Set trunking characteristics of the interface
voice Voice appliance attributes
12-03-2013 02:44 AM
Mac based acl feature doesnt exist
12-03-2013 01:36 PM
Mac based acl feature doesnt exist
Yes it does. Below is taken from my cheap 891 router:
Router(config)#access-list 700 permit ?
H.H.H 48-bit hardware address
12-04-2013 01:13 AM
Hi Leo,
I can see that command is available but i dont see an option to bind it to fastethernet 1.
12-04-2013 01:29 AM
Hi Leo,
Yes you can configure a MAC ACL but can you bind it to a L2 interface ?
And if you can will it behave like on most switches that is only filter non IP traffic which in this case won't solve the OP problem ?
Regards
Alain
Don't forget to rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide