cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
754
Views
0
Helpful
4
Replies

telnet to fresh cisco router

Hi masters,

1. Why cisco is not like tp-link wireless router that have a default-ip that can HTTP-ing / telnet directly out-of-box using Ethernet cable not Console cable?

2. How to telnet/manage fresh cisco router 891 without console cable (I can't acquire it yet)? I have acquired the default ip add. of the router from the manual page: 10.10.10.1 and it is pingable but I can't telnet, SSH, HTTP and HTTPS, they fail.

3. Is it a console cable is a MUST to setup/configure/manage a out-of-box router?

 

Thanks

 

1 Accepted Solution

Accepted Solutions

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

#1 only Cisco could say for sure, but likely because many Cisco devices are "professional" grade, not home units.  So, they aren't as user friendly.

#2 Often, you cannot.  If the device has a dedicated (Ethernet) management port, its default configuration might pick up a DHCP IP and allow you to telnet to the device on it.

#3 Often it is.  New out-of-the-box Cisco devices include (or at least used to) a console cable in the box.

View solution in original post

4 Replies 4

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

#1 only Cisco could say for sure, but likely because many Cisco devices are "professional" grade, not home units.  So, they aren't as user friendly.

#2 Often, you cannot.  If the device has a dedicated (Ethernet) management port, its default configuration might pick up a DHCP IP and allow you to telnet to the device on it.

#3 Often it is.  New out-of-the-box Cisco devices include (or at least used to) a console cable in the box.

Hello

 

1.    I guess for security reasons , So to allow acccess you need to manually alow it.

2.

username xxx password xxx
enable secret password

line vty 0 15
transport input telnet
login local

3

Line console 0
login local

 

res

Paul


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Thanks for yours

 
Review Cisco Networking products for a $25 gift card