12-11-2012 03:17 PM - edited 03-04-2019 06:23 PM
Hello,
I am using a Cisco ME 3800 switch with 24 Gig and 2 Tengigabit interface. But after configuring the Tengig int with ip add and negotiation it is no know visible in the switch. Instead TenGig I am seeing two (Gi0/1 and G0/2). Not even showing the Tengig in the running config. PFA.
Hope any one in the forum has the solution to get the tengig interface in the running config visible.
12-11-2012 03:19 PM
am using a Cisco ME 3800 switch with 24 Gig and 2 Tengigabit interface. But after configuring the Tengig int with ip add and negotiation it is not know visible in the switch. Instead TenGig I am seeing two (Gi0/1 and G0/2). Not even showing the Tengig in the running config.
Hope any one in the forum has the solution to get the tengig interface in the running config visible.
12-11-2012 03:27 PM
I'm in deploying ME3800X. My interfaces (without SFP/SFP+) are known as "TenGigabitEthernet0/1" and "TenGigabitEthernet0/2".
12-11-2012 04:32 PM
Hi Leo,
Thanks for ur reply.
If I am not wrong here I have to use SFP+ for Tengig interface so that the media type could be recognized.
10/100/1000BaseTX SFP will not work in Tengig port.
07-30-2013 12:30 PM
After inserting SFP+ modules this got detected.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide