to find the QoS dscp value of the source and destination using the sh ip cache flow output

thiyagarajankalaiselvan · ‎09-21-2015

Hello All,

I'm trying to find the QoS dscp value of the source and destination using the sh ip cache flow output.

Could you please help me to find the DSCP value used by the source/destination from sh ip cache flow output?

Is there any command which will help me to find the DSCP value used by the source/destination?

Regards,

Thiyagu

paul driver · ‎09-21-2015

Hello

Try using the verbose flow - sh ip cache verbose flow

TOS value divide by 4, that shoud give you the DSCP value.

res

Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul