Can anyone point me in the right direction about the following situation?
We have a router that is receiving about 400-430Mbps of traffic in its LAN interface, but is only transmiting around 320-350Mbps over the WAN link. There are no drops in the WAN interface, I can no see any drop using the #sh policy-map int Gi0/0/0 out. Our first approach is that the gap is due to inter VRF routing but the client is not accepting that answer. I'm far of being an expert in QoS so any help would be greatly appreciated.
Hello I am getting this following error and get ACTV, XPS and S-PWR LEDs amber then suddenly all LEDs are off: Booting...(use DDR clock 667 MHz)*** Coprocessor Unusable Exception ***PC = 0x00000000 00000000SP = 0x00000000 00000000Cause Reg...
Once Cisco DNA Center has provisioned the SD-Access devices to sites, the SD-Access fabric can be created. In the Cisco DNA Center UI, navigate to Provision > Fabric. This is where you create and manage your fabric domains and transits.]
Provision Discovered Devices
On the Cisco DNA Center UI, navigate to Provision page
Select the following devices and provision all the devices to Floor-1. During the provision workflow, Cisco DNA Center can only provision devices of similar family. We wi...